BLCKTEC 410: How to READ and ERASE codes

Purpose

To provide you with steps on how to read and clear codes while using the BLCKTEC 410

Step 1 -Select Scan Engine

After pairing your BLCKTEC 410, select the Scan Engine. The scan engine runs a monitor test for the check engine light and creates a report detailing your engine's specific problems.

Step 2 - Wait until the app reads the data from your vehicle

The RS2 app will read the data from your vehicle, including the odometer.

Step 3 - Select Generate Report

After your vehicle's odometer is read by the app, select Generate Report.

While generating the report, ensure your vehicle is turned to the ON position, and your smart device is close to your BLCKTEC 410.

Once the report is generated, a Done message will be shown on the screen.

Note: Your vehicle’s odometer mileage should automatically be recorded in the odometer field.

Step 4 - View the Report Page

The Report Page will appear after the mobile app is done generating the report. It will show the number of codes found and a Results link that navigates to your codes in detail. To access the DTC codes list, select Results.

Step 5 - Select Erase Codes

If you want to clear the report after completing repairs, you can erase the vehicle's codes. Scroll down the screen and select Erase Codes.

Step 6 - Select the codes you wish to erase

After selecting Erase Codes, a dialog screen will appear that will let you select the codes you wish to erase.

Step 7 - Select Continue

After selecting the codes you want to be erased, a successful deletion prompt screen will appear to notify you that the system successfully completed erasing your codes.

Select Continue to exit.